Uniden bts200 manual

Bass output Hear the bass sound. Page 11 BTS is turned off. Slow blink BTS is looking for paired Bluetooth devices. Steady on BTS is connected to a Bluetooth device. BTS is not connected to a Bluetooth device. Press and release the keys to increase or decrease the volume level one step at a time. Page Call Waiting To Do this Unmute the microphone Press again. The LED turns off. Redial the last incoming From standby, press at the same time. The number LED is steady green.

From standby, press and hold. The LED is Redial the last number dialed steady green. Page 14 To Always give full attention to driving and pull off the road and park before making or answering a call if driving conditions require. With Bluetooth V2. You can also connect your music player wired or wireless for crisp, clear audio.

The BTS speaker is not a data storage device; do not attempt to copy files to it. Remove the battery from any protective packaging and discard the packaging accordingly. Align the battery pack with the guides along the inside of the battery area.

Be sure the contact slots are in the correct position to close on the contacts. Slide the battery in until you hear the latch click. Plug the adapter into a VAC power supply standard wall outlet.

The middle LED lights to indicate the battery is charging and goes off when complete. Your battery must be fully charged more than 7. When you turn on your speaker for the first time, it automatically goes into pairing mode.

The Bluetooth LED flashes rapidly and is ready to pair see page 6. The next time you turn on your speaker, it searches for already paired devices and then moves into a standby state. Press and hold for at least 3 seconds. All LEDs light and a power on tone sounds. Insert the microSD card into your computer an adapter may be necessary. Copy the firmware to the root directory of your microSD card. Eject the microSD card and place back into your AppCam. Connect the power to your AppCam. The AppCam will install the firmware.

Note: It may be necessary to perform the initial setup again for the AppCam and your mobile phone application. This installer creates the following driver on your system: v2. Page 8 BTS is turned on and operating. BTS is turned off. Slow blink BTS is looking for paired Bluetooth devices. Steady on BTS is connected to a Bluetooth device.

Battery release latch Unlock the battery for removal. English - Page Bts Back Bass output Hear the bass sound. Press and release the keys to increase or decrease the volume level one step at a time.

Page Basic Cell Phone Operations Your speaker sounds an alert tone when it reaches the maximum upper and lower volume levels. Both the speaker and your cellphone may ring, depending on your cellphone settings.

Page Call Waiting To Do this From standby, press and hold. The LED is Redial the last number dialed steady green. Set up a conference call 2.